Indoor Gas Line Installation in Etobicoke

$320 – $1,800 installed depending on run length, fixtures served, and whether Enbridge service upsize is required. Most kitchen / dryer / fireplace adds land at $580 – $1,100. Free site assessment quotes the exact number.

No. Gas work in Ontario requires TSSA G2 or G3 certification — homeowner DIY is illegal. Insurance won't pay claims on unlicensed gas work. We coordinate licensed gas fitters; you sign one contract with us.

Yes — both TSSA permit (our gas fitter pulls) AND Etobicoke Building Permit for any new gas piping inside the building envelope. Enbridge inspection is also required before turn-on. We handle all paperwork.

G2 is the full gas fitter license — any gas work, any appliance. G3 is limited scope — single-fixture installs only (e.g. one gas range hookup). Both are valid for indoor gas work. We default to G2-licensed sub-contractor partners for flexibility.

Both are CSA-approved. Black iron is durable and traditional — best for exposed runs. CSST (TracPipe, Wardflex) is faster to install through walls and joists — best for retrofits. CSST must be bonded to the electrical grounding system per CSA B149.1 (lightning protection). We choose based on routing — both end up the same price-per-foot installed.

4-8 hours for short single-fixture run. 1-1.5 days for longer runs / multi-fixture. Enbridge inspection adds 1-3 business days lead time on first turn-on.

Enbridge upsizes the meter & regulator for free. We charge $300 – $1,500 for any line modifications + new larger inlet piping needed. Lead time 2-4 weeks for Enbridge service upgrade. We plan around this at consultation.

New gas appliances must be reported to your insurer (typical insurance T&Cs). Licensed install + Enbridge inspection + permit close-out gives you clean documentation — most insurers approve without rate change. DIY or unlicensed work voids coverage — never do this yourself.

Indoor gas work in non-downtown postal codes: yes, no restrictions. Downtown core (M5A-M5V): 2-3 day buffer recommended May 1 – July 31. We schedule around Enbridge inspector availability.

Both supported. Inserts (existing wood fireplace → gas insert): line run + insert install + venting check. $1,200 – $2,800 total (most of cost is insert + venting, gas line is $400-$700). Free-standing direct-vent: $980 – $1,800 line + $1,500-$3,500 unit + venting. We coordinate with fireplace specialty installers.

Properly installed, leak-tested, and pressure-verified gas lines have an excellent safety record. Hazard sources: (1) DIY unlicensed work (top cause of claims), (2) damage during renovation (we tag and protect lines during demolition), (3) shutoff valve failure (we use OSC ¼-turn ball valves — superior to old gate valves). Carbon monoxide detectors per OBC 9.32 + gas detectors recommended near appliances. We test every installation with combustible-gas detector at commissioning.