Second Egress for Basement Apartment in Richmond Hill

Ontario Building Code 9.9.5 requires every dwelling unit to have an unobstructed means of egress that does not pass through another dwelling unit. The typical existing Richmond Hill basement apartment exits up an interior stair into the main-floor unit's hallway, which violates this rule. A second egress (exterior stair to grade, or a walkout door) creates a code-compliant exit path. It is also a life-safety must — if the main-floor unit has a fire blocking the interior stair, the basement tenant needs another way out.

Egress windows in bedrooms (OBC 9.9.10) satisfy the bedroom-egress rule but do NOT satisfy the unit-egress rule under 9.9.5. The suite still needs a direct exterior exit. So while egress windows in every bedroom are required, you ALSO need either a walkout door or a walk-up exterior stair somewhere in the suite. The two requirements are stacked, not alternatives.

Not required by OBC. However, an uncovered stair fills with snow and rain. Premium-tier projects include a polycarbonate or aluminum bulkhead cover to keep the stair clear, prevent ice buildup, and reduce drainage load. RenoHouse strongly recommends a cover in any project where the suite faces a busy rental market and tenant retention matters.

Often, on narrow Richmond Hill Old City lots. Side-yard setback requirements (typically 1.2 to 1.5 m minimum) are difficult to satisfy when adding a stair pit to a 5-foot side yard. Most projects on 18 to 25-foot frontage lots need a minor variance, which adds 12 to 16 weeks. Wider lots (35+ ft frontage) typically accommodate the stair within setback as-of-right. RenoHouse handles the COA application as part of Standard tier.

Not if drainage is properly designed. The standard RenoHouse spec includes a perimeter drain at the base of the pit (tied to existing weeper or new sump), a curtain drain intercepting upstream groundwater, a sloped landing pad with positive drainage away from the door, and self-adhered membrane on the foundation cut. Poorly-built projects (no perimeter drain, no curtain drain, no membrane) routinely flood — this is the most common second-egress failure mode and the reason we never skip these details.

Yes. Most second-egress projects are retrofitted to existing basement apartments as part of permit-prep. The work is primarily exterior; interior impact is limited to demolishing finishes around the new door opening and re-finishing those few square feet. The tenant can typically remain in the suite during construction except for the 1-week foundation cut phase.

OBC 9.9.8 limits a single stair flight without a landing to roughly 14 risers. At a typical 195 mm rise, that's 2.7 m of vertical drop. Most basement floors sit 1.5 to 2.4 m below grade, so a single straight flight handles all common configurations. Deeper pits (over 2.4 m drop) require an intermediate landing midway.

Most Richmond Hill R-zones require 1.2 to 1.5 m side-yard setback for principal-building elements. A second-egress stair pit must either fit within the side yard (typically 1.5 m wide for the pit including retaining walls) or apply for a minor variance via Committee of Adjustment. A pit under 0.6 m wide may qualify for the encroachment exemption under By-law 569-2013. The audit confirms the specific zoning rule for your property.